Smart 4mm PTFE Tube Connector
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Smart and versatile tube connector.
- Ocena
- 4,846 / 5
- Polubienia
- 114
- Pobrania
- 857
- Wydruki
- 12
- Wyświetlenia
- 2382
- Oceny
- 13
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Heyho
Here I have a PTFE Tube Connector for the standard 4 mm ones. I use them at my XL to connect my Teflon tubes from the dryboxes to the ones sticking out of the first Filament sensor.
The features:
A segmented inner area for a good force distribution/ clamping strength without deforming the tube
100% Scalability:
3 Prescaled Models: Soft Medium and Strong clamping force (1, 2 , 3 Dots)
If you only want to change the clamping pressure just scale the X/Y Axis! If you just want to change the length without changing the clamping force just scale the Z Axis.
This way you can also scale the Adapter fitting to other tube diameter.
Wide ends to increase first layer adhesion and a better grip if you want to push them on the tube with a higher clamping force.
Viewing window to check that the 2 hoses touch perfectly.
Assembling
To test the best fitting I would recommend to start with the strong one (I use that) or just print all 3 Versions first and then multiply the best fitting ones. Or Scale them to your needs!
You can add a little chamfer on each Tube end but more important is to cut the ends off 90° as good as possible.
If they fit correctly there will be no gap between the 2 Ends.
Printing: I printed mine with PLA, 0,2mm layer Height & standard Infill. Seam set away from the window.
PS: I intentionally did not design a hard stop in the middle of the connector to make the transition between the tubes as smooth as possible.