1 / 7
Under case fan duct for Lian Li O11 plus most other cases with bottom mount 120mm fans — zdjęcie 1
1 / 7

Under case fan duct for Lian Li O11 plus most other cases with bottom mount 120mm fans

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Use these ducts to draw air from beside your case, not directly from carpet, underneath case. Cooler and cleaner PC.

Ocena
0 / 5
Polubienia
58
Pobrania
306
Wydruki
0
Wyświetlenia
2938
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Don't want to suck hot carpeted air, dust and dirt into your expensive GPU and case? Want cooler temps and higher airflow?  Use these ducts to pull air in from beside the case not directly and immediately beneath it. Position them pointing either side, though they are sized to just peek out from the glass side on a Lian Li O11 series of case.

Likely fit any 120mm fan mounting on any case, sized to minimally do the job. Optionally add in a slim 120mm Fan Dust Filter between the duct and Case to further stop dust ingress. Use 20-30mm wood screws or similar (or long versions of the standard PC Fan screw) to screw straight into fan on other side.

 

Recommend Printing either with the two small openings on print bed (ie vertically) and minimal supports (or none) OR with the either the top or bottom on bed an deal with supports. Interior is tapered and filleted as much as possible for strength and also printablity. 

Tagi