K1/K1 Max 3dChameleon Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I created a mount which slides underneath the printer and hold the 3D Chameleon in place. No fasteners are needed.
- Ocena
- 0 / 5
- Polubienia
- 57
- Pobrania
- 119
- Wydruki
- 0
- Wyświetlenia
- 6636
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I have my printer flush against the wall so was not able to use the mounting place provided by Bill at 3dChameleon. I created my own version which is minimal and is held in place by friction and weight of the printer itself.
Use at your own risk! I have not done enough testing to advise on any effect from the heat generated onto the side acrylic. There is also a chance a stuck filament will drag the printer and the entire table into the dark abyss. Happy testing!
Note: Pictures of v1 where the cutouts for the outside bolts were 6.5mm. In v2, I have widened them to 7mm to fit bitter and made them partial instead of all the way through.