SV07+ Modern Front Plate + Drawer With Optional Cooling Fan!

After many many spare time and tests, i've redesigned the sv07+ front plate to be modern, thin, and sleek. It does come with the matching drawer too! I originally made this because my ambient air temperature is always very warm and this caused the MCU of the printer to get very hot. Now there is a place for a fan! but if you don't like fans, you can print the modern new front plate and drawer because you just can! This is also great for thoughts looking to add a different color to their printer.

This reuses the same mounting holes and bolts. you do not need anything else. I printed this in PETG for the heat resistance but im sure PLA would work just great. If you want to use the fan, there is an open fan port on the motherboard, it is a 24v 40x10 fan.  The fan goes on the open port PE10, which to access you will need to open the bottom panel. The code you will need to make the fan work is just a slight change to your existing MCU fan code. It should now be:

[multi_pin mcu_fans]
pins: PD3,PE10

[temperature_fan MCU_Fan]
pin:multi_pin:mcu_fans
max_power: 1
shutdown_speed: 0
cycle_time: 0.100
hardware_pwm: False
kick_start_time: 0.100
off_below:0.05
sensor_type: temperature_mcu
control: watermark
max_delta: 3
min_temp: 0
max_temp: 80
target_temp: 40.0
max_speed: 1.0
min_speed: 0

I printed this at a 45* angle to make it one solid print, if the holes do not line up you need to do a large step calibration on your printer to get the measurements to be exact. i used orca slicer with a 0.4 nozzle. layer heights 0.2, line widths 0.36, infill width 0.44, resolution 0.1, inner/outer print order, wall loops at 3, shell layers at 3, 25% infill, no brim, Tree supports are required and i used auto trees with a threshold angle of 15*

I do appreciate helpful feedback, and i will improve this if you tell me how i could do that.