Anker 737 Charger case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A travel case for the Anker 737 Charger and a 6ft or shorter charging cable.
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 37
- Wydruki
- 1
- Wyświetlenia
- 1269
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
Intro:
This is a travel case for the Anker 737 GaNPrime 120W Charger and a 6ft USB-C to USB-C charging cable. A smaller cable will fit just fine, but 6ft is the max.
Print settings:
I printed this all in PLA with 0.2mm height. I haven't tested any other filaments.
Supports:
This print is support free.
Variations
I have 2 variations on the lid. One to hold the suction cup brace and one without the brace for a lower profile.
Hardware:
The hinge takes two M3 x 25mm screws and the magnets are 3x6mm. The 2 screws install from either side of the hinge to meet in the middle.
Notes:
This prints in two pieces with both having the outside facing down on the print surface.