Anker 737 Charger case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A travel case for the Anker 737 Charger and a 6ft or shorter charging cable.
- Rating
- 5 / 5
- Likes
- 9
- Downloads
- 37
- Makes
- 1
- Views
- 1,269
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial
Intro:
This is a travel case for the Anker 737 GaNPrime 120W Charger and a 6ft USB-C to USB-C charging cable. A smaller cable will fit just fine, but 6ft is the max.
Print settings:
I printed this all in PLA with 0.2mm height. I haven't tested any other filaments.
Supports:
This print is support free.
Variations
I have 2 variations on the lid. One to hold the suction cup brace and one without the brace for a lower profile.
Hardware:
The hinge takes two M3 x 25mm screws and the magnets are 3x6mm. The 2 screws install from either side of the hinge to meet in the middle.
Notes:
This prints in two pieces with both having the outside facing down on the print surface.