Grado Labs SR 60 Grill + GCush adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Two versions of mesh grill and an adapter for the snug fit of G-type Cushions for the SR60 and compatible models.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 289
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution
These are my take on custom grills for the Grado Labs SR60 headphones and an adapter for the G-type cushion.
The v1 version of the grill is hard to print cleanly. Check your retracts, and be prepared for lots of fun in the slicer (or the post-processing).
The v2 version, on the other hand, is easy to print and deburr. Printed in coPET (PETG), the mesh is flexible enough to be forced inside the cup. Be aware that it features a 15-degree inverted cone, that clips tightly in place. You will not be able to rotate the mesh once it is in.
The adapter fills the gap in the outer surface of the cup and provides a larger lip to hold the cushion. It should fit both the shell and the cushion very well. No flex is required, so printing in PLA could be acceptable. (Note: I am aware that I am not the first to make such an adapter, but it was designed from the ground up, so this is not a remix)
I hope these models suit your needs.
Please visit https://u24.gov.ua/ to support my existence. Thank you!