1 / 2
Fractal Design Ridge anti-sag bracket for Palit 40 series Jetstream GPUs — zdjęcie 1
1 / 2

Fractal Design Ridge anti-sag bracket for Palit 40 series Jetstream GPUs

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Bracket made for Palit 40 series nvidia GPUs to completely remove gpu sagging and load from pci-e connector

Ocena
0 / 5
Polubienia
5
Pobrania
26
Wydruki
0
Wyświetlenia
1710
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Public Domain

Bracket is designed around “Palit GeForce RTX 4080 Super JetStream OC” backplate holes(made for Palit vga holder) and Fractal Design Ridge case, but it seems like that exact the same backplate(as well as cooling solution) is shared on numerous 40 series jetstream GPUs which has 329mm length, specifically:

4070 (Super) Jetstream

4070ti (Super) Jetstream

4080 (Super) Jetstream

Hole pattern might actually be shared with gamerock and gamingpro series as well, at least it looks similar on photos, but due to obvious reasons i can't tell it for sure.

Applying this bracket transfers load from pci-e connector to backplate which effectively gets locked between i/o shield and this bracket, so GPU backplate basically turns into structural part of the case.

 

23.03.2024 update:

  1. Reduced part width by .45mm in attempt to remove interference with side panel lock
  2. Added “BACKPLATE FACE UP” text to the side which should face GPU backplate 

 

BOM:

  1. 2xM3xD5xL4 Threated heat inserts
  2. 2xM3 BHCS(DIN 912) Screw 8 mm
  3. 2xM3 SHCS(DIN 7380) Screw 8 mm 

In fact, any M3 6-8mm long screws will most definitely fit, bom is written around what i had on hands

 

Printing recommendations:

  1. Avoid using low temp plastics like PLA, even thou this part mounts to “cold” edge of a GPU case still getting pretty hot inside during gpu load
  2. Part is oriented for printing, no supports required
  3. 4 perimeters and 30% infill with .4 nozzle, 4 top 4 bottom solid layers should be more than enough for this part to be strong if printed with ABS, I've printed this part with ABS-CF15, 0.5 nozzle, 3 walls, 30% gyroid infill, 4 top 3 bottom solid layers and it feels rock solid

 

Assembly:

  1. Put heat inserts in outer holes of a bracket
  2. Untighten GPU i/o shield screws
  3. Attach bracket to GPU with BHCS screws with “BACKPLATE FACE UP” text facing GPU backplate side
  4. Attach bracket to a case with SHCS screw
  5. Tighten GPU i/o shield screws, better to do it with case in vertical orientation, so GPU sets in the most “relaxed” state

 

Base sketch in .f3d ("Dimentions") includes construction line which represents case cutout closer to a top of a case(vertical orientation assumed in manual), for anyone who would like to adapt this design for their gpu(you'll still need to figure out heigh difference between holes because idk how to represent everything in sketch without making it confusing)

Tagi