1 / 7
E3D  Revo Roto ToolChanger Blower Fan Duct and Mount — zdjęcie 1
1 / 7

E3D Revo Roto ToolChanger Blower Fan Duct and Mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Part cooling fan duct and mount for the E3D ToolChanger and Roto Extruder.

Ocena
0 / 5
Polubienia
7
Pobrania
49
Wydruki
0
Wyświetlenia
595
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

About

This is a part cooling fan duct and mount for the E3D ToolChanger and Roto extruder. It is designed around the WinSinn 4010 blower fan and supports the attachment of the Duet Roto Toolboard.

Printed Parts List

  • PCF Duct
  • Toolboard Adapter
  • Fan Bracket (optional)
  • Plate Adapter
  • Plate Adapter with Switch Lever (optional)
  • Dock Brace
  • Washer x 2 (optional, on top of tool board)
  • roto-duet-toolboard-tc-cable-support (for use with Duet Roto Toolboard)

Additional Hardware

4x 8mm M2Part fan retaining screws
4x 12mm M4Pan head self-taping screws (comes with Roto kit) to secure motor
2x 8mm M3        Fan duct to plate adapter
1x 8mm M3Fan bracket to tool plate adapter
2x 12mm M3Plate adapter to Dock Brace
2x 10mm M3

Dock Brace to tool changer receiver

 

6x 8mm M3Countersunk screws for tool plate mounting
2x 6mm M3Tool board adapter to tool-changer receiver
2x 6mm M3roto-duet-toolboard-tc-cable-support to tool changer receiver.

Unless otherwise noted, these are all assumed to be socket head cap screws.

Print Settings

0.4 nozzle.

0.2 layer height.

3 perimeters.

4 top layers, 3 bottom layers.

15% infill.

Shouldn’t need support structures, but a couple of places on the PCF Duct may print better with them.

I printed it with PC-CF filament for added stiffness and heat resistance.

Additional Notes

The ‘Plate Adapter with Switch Lever’ part is intended as an optional alternative to the ‘Plate Adapter’ and includes an extension which can be used to trigger a switch located on the tool head when the tool is picked up.

The ‘Fan Bracket’ part provides some extra rigidity and support for the fan but it’s use isn’t absolutely necessary.

Attributions

The fan duct was inspired by Rene Jurack’s Well-Engineered Hemera fan duct, which can be found here: 

https://rene-jurack.de/well-engineered-hemera-fan-duct-2

The ‘roto-duet-toolboard-tc-cable-support’ part comes from the E3D Revo Roto Toolchanger Mount, which can be found here:

https://www.printables.com/model/802772-e3d-revo-roto-toolchanger-mount

 

Tagi