Ender 3 V3 KE 2510 to 3010 fan adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An adapter to mount a larger 3010 fan in place of the smaller 2510 stock fan,
- Ocena
- 4,333 / 5
- Polubienia
- 100
- Pobrania
- 629
- Wydruki
- 4
- Wyświetlenia
- 4319
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
For various reasons I wanted to replace the stock 2510 fan of my KE's hotend with a larger and more effective 3010 fan - keeping the original hotend shroud/cover as is. K1 and K1Max hotends have 3010 fans whereas KE has a smaller 2510 (cost/weight-cutting?) which from personal experience is louder, not easily procured in some markets and has understandably smaller cooling capacity than a 3010.
The adapter is mounted on the heatsink with two screws from the existing fan setup on the same place the original fan sits. The 3010 fan is mounted on the adapter with two screws for which unfortunately the other two screws from the original setup cannot be used since the are ridiculously short (cost/weight-cutting?) You'll need a 2mm (diameter) and 15mm (length) screw to comfortably mount the fan on the adapter. Original screws are aprox. 1.88mm in diameterer and 11mm in length.
The fit is snug so make sure the cable from the fan is on the upper left corner (alogside the extruder motor). Use PETG, ASA or ABS.
P.S.1. In case you don't know the specs, you'll need a 3010 24 volt fan with a 1,25mm JST-like connector. Usually fans are sold with larger JST connectors but you can buy 1,25mm JST-like connectors separately which come paired with cables. Note: Double check the polarity of the connector, on mine it was the opposite.
P.S.2. Since I had a related comment I wanted to clarify that no other modification is needed, everything is kept stock.