Ender 3/PRO/V2 | Adjustable Silicone Feets - Very Grippy

Reuse your old silicone bed mounts into four very grippy feets.

I was tired of my Ender 3 V2 moving on it's own with the stock bad feets. I also needed to raise the whole machine to convert it to the Voron theme. So I took some time in TinkerCad and Fusion 360 to design four feets that would do both.

You will need four bed silicone spacers. You might already have some. There are multiple sizes for them. You need these spacers at least 16mm tall (the ones you see everywhere on Amazon or Ali)
Link : https://fr.aliexpress.com/item/1005003328972027.html

There also are three versions of the feets. Slim, Large, Tall and Short. Short is for 16mm spacers, tall is for upper. I have 26mm feets so I am using the long version.

Slim is for the back of the Ender 3 V2. It needs to be slimmed to not collide with the power supply bracket.

===HARDWARE===
-4 M4 screws
-4 M4 bolts
-Optionally 4 M4 washers for the screws not to slip in the spacers

===ASSEMBLY===
-Slide your 4 screws into each spacer, making sure the head of the screw is in the side where there is a hole in the spacer. 
-Put your 4 M4 nuts into the feets (I made sure to have a very tight clearance for it to not move, heating and screwing the bolt from the other side is recommended).
-Screw the spacers into the bolts. Loosely for now.
-Mount your four feets onto your Ender 3 frame. 
-Tighten screws until your feets don’t wobble.

Hope these models will help. If you have any questions, feel free to ask in the comments !