1 / 11
OUTDATED! See link in description for version 2 — zdjęcie 1
1 / 11

OUTDATED! See link in description for version 2

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This Switch cartridge holder fits in the palm of your hand! 2 designs - one uses magnets, one doesn't.

Ocena
4 / 5
Polubienia
11
Pobrania
62
Wydruki
2
Wyświetlenia
272
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Video Games
Licencja
Creative Commons — Attribution — Noncommercial

Check out my newest version of this cart holder here!


– Nintendo Switch Cartridge Holders! – 

Please let these prints cool ON the bed! If they warp, they will not sit flush!

I wanted a small cartridge case to replace this, which was too tight and made my games go flying every time I opened it. I wanted it to be small enough to fit in this carrying case, and I needed it to fit at least four games. 

After a handful of iterations, I came up with two designs!

Design 1: 4 cartridges (no magnets)

This design can be used on its own or with a slim cover. The cartridges fit snugly into the cutouts (sometimes a little too snug depending on the cartridges – they vary slightly), and you can push them out from the back. The cover is a bit loose and is meant to protect the front of the cartridges while inside a carrying case, rather than to be used as a carrying case.

Design 2: 8 cartridges (8 magnets)

This design takes two of the basic holders and sticks them together with 5x2mm magnets. The case works the same as the other, except there is no need for a cover because the cartridges all face the inside of the holder. Simply dab a bit of superglue in the holes and press the magnets in. Make sure you orient them so the two pieces attract rather than repel each other!

– – – 

Thanks for looking! I'm still new to modeling, so please let me know if there's anything I can improve!

Tagi