15degree screw on roof shim
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
15 degree angle shims for roofing.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 154
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Public Domain
I did not want to cut the beams my roof should rest on at a 15degree angle and did not want to bend the metal angles (90 degrees) from the home depot.
Solution: 15 degree (the minimum any roof should have for letting the rain run down) shims with screw holes!
I also made them for the round bits that go under the wavy plastic roofs (in slim and with a 2mm height boost, as the fence I screwed it on was not level). Works well and looks better this way.
Print without supports on bottom (not on the side). I printed them with 0.3mm layer height and 0.6 nozzle in PLA with 4 perimeters (to support the pressure in the centre when screwing).