Nutstein Parallelanschlag Bosch GTS 10 XC
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This model is a hammerhead nut specific for the parallel guide of the Bosch GTS 10 XC table saw.
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 105
- Wydruki
- 1
- Wyświetlenia
- 839
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial
This model is a hammerhead nut specific for the parallel guide of the Bosch GTS 10 XC table saw.
You can use it to mount your specific attachments, like
- feather boards
- router table parallel guides for an integrated router
- or whatever you can imagine
You'll need a 6mm nut acc. to DIN 562 (low profile square nut) to be printed in.
I ordered this ones from Amazon: https://amzn.eu/d/6zvtiov
Pause after 3.8mm height, insert the nut and continue the print.
I added a adapted model with thin layer above the nut in order to improve print quality (see 3rd picture that shows the cross section).
Just insert a Screw from the bottom side in order to break the thin layer.
Evtl. you need to use a sharp knife resp. nippers in order to clean the hole.