V-Slot Heavier Duty Wall Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A wall mount for 2020/2040 extrusions designed for use with #8 drywall screws
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 40
- Wydruki
- 0
- Wyświetlenia
- 197
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Public Domain
I had a need to mount some 20x20 extrusion on the wall and the only existing model I found was too small and light duty, so I designed this instead (see comparison photo).
This is designed to be a fairly close fit so you might have to scale it a bit depending on your particular flavor of extrusion. It should be printed in the default orientation for maximum strength. Minimal supports are needed if you want the screw hole to be as nice as possible. I'd also recommend increasing the number of perimeters for even more strength.
I don't think you can hang your 3D Printer from the wall with these but I'm using them for holding a mini PC and a full size external hard drive under my desk without worry of them falling.