Robot wheel for 4mm shaft with flat
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This a an ~80mm wheel for direct coupling on a 4mm 'D'. This has been tested with the DFRobot FIT0521 motor.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 176
- Wydruki
- 0
- Wyświetlenia
- 989
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- GNU General Public License v3.0
This design is part of a differential drive robot. The wheels are approximately 78mm in diameter. The wheel can directly couple to a 4mm ‘D’ shaft, where the flat spot is 3.5mm across from the width of the shaft.
The wheel can be used as is printed in PLA or PETG. An optional non slip tyre printed from FLEX can be used to improve grip. The tyre will slip the existing tread and hold in place.
The photos show it printed in 0.2mm PLA. If over-extrusion is negatively impacting the ability to fit the shaft into the hub or m3 nuts for the screws, then I suggest using variable layers to add more resolution to the hub.
Details of the motor seen in the photos is can be found at https://www.dfrobot.com/product-1617.html