1 / 4
80mm fan power supply cover (Sovol SV06/Plus) — zdjęcie 1
1 / 4

80mm fan power supply cover (Sovol SV06/Plus)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Fits a 80x10mm 24v fan inside the PSU No mounts for buck converter Good air flow and low noise Made for SV06 Plus

Ocena
5 / 5
Polubienia
14
Pobrania
114
Wydruki
2
Wyświetlenia
563
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Why use this?

The original fan is extremely loud and annoying, so I chose to use a larger and slower rpm fan.

With this, you can mount a 80x10 mm 24v fan on the inside of the PSU cover. There is also space to add a buck converter if you are using a non 24v fan, I didn't include the mounts for the converter as I chose to use a 24v fan.

The cover works on the

CHENGLIANG P360W24V of the SV06
CHENGLIANG P500W24V of the SV06 Plus
and probably* many others, as these PSU's seem quite generic. *(haven't tested)

 

You'll need:

1x 80x10 mm fan (I bought this one from amazon)
6x M3 Threaded heat inserts
6x short M3 flat head screws (you should already have these from the original cover)
4x M5 flat head screws (Fan screws)

 

Edit

Tweaked the model after I printed mine to improve on appearance and printability. No more sloped edges on fan grill, no bevel on fan grill, and small geometry problems.


Print setting

Must use supports!
Infill recommended, 30-50% for the threaded inserts
2 perimeter walls with 0.2 layers, more than that might create some unwanted gap fill

 

Remixed from
Thomas Albrecht

 

!! Danger Note !!

You don't need to remove the board from the case (just the cover), but you will still be working with 110/230V, so be extra careful. Not doing so might result in death or serious injury.

Tagi