Front Endoscope Camera Mount for Prusa Mini
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An endoscope camera mount for the Prusa Mini.
- Ocena
- 0 / 5
- Polubienia
- 19
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 375
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- GNU General Public License v2.0
Add a nozzle camera using a Endoscope (Borescope) camera!
I found that the original endoscope mount (https://www.printables.com/model/63283-prusa-mini-endoscope-mount) was hitting the back screws of the build plate, moving the nozzle fan out of the x-carriage piece. Also, I didn't want to have the camera pointed to the front (where it would capture people passing by), so I built a holder that points towards the back of the printer.
This piece replaces the original M.I.N.D.A./SuperPINDA holder piece. You will need a M3 nut (which can be taken from the original piece) as well as the original screws.
I'm using a 8mm endoscope camera, which fits nicely in the holder. There is a M3 slot at the top to have a M3 screw that should make it compatible with smaller cameras as well.
My print settings:
- Material: PETG
- Layer height: 0.3mm
- Infill: 100% (probably less infill is fine)
After replacing the piece, make sure you set up the M.I.N.D.A./SuperPINDA sensor again: https://help.prusa3d.com/guide/height-adjustment-of-m-i-n-d-a-superpinda-sensor-mini-_154547