Key holder key + CAD
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A key to organize your keys. Supportless print!
- Ocena
- 4,778 / 5
- Polubienia
- 91
- Pobrania
- 928
- Wydruki
- 10
- Wyświetlenia
- 3614
- Oceny
- 9
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A key holder with 2 screws holes to fix it to a wall.
PLA, Generic 0.25mm Draft mode profile in Prusaslicer
Model aligned at 45 degrees on the bed fo straight solid infill lines. This allows to to use the default infill direction using X and Y motors to do the infill without even changing the parameters of the infill direction. It is easier on the machine et let a better looking edges even if your filament properties are not exactly on point.
2.450mm height for the core to be strong enough and with a perfect profile fit as the first layer is 0.2mm and all the others are 0.25mm. The natch in the key is exactly at 1.95mm so it is extacly 2 layer less than the main core so all the solid infill lines will be aligned at the end of the print for a better finish. All the edges are a little rounded to avoid sharp edges