1 / 3
John Deere 1 series tractor seat belt stop — zdjęcie 1
1 / 3

John Deere 1 series tractor seat belt stop

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Fix for unwanted seat belt/fender damage.

Ocena
0 / 5
Polubienia
1
Pobrania
24
Wydruki
0
Wyświetlenia
513
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

If you own a John Deere 1 series TLB or FILB tractor and your like me, you find the seat belt setup frustrating and annoying. If you leave them up and tighten them down, you can't turn the seat around. But if you leave them loose, they flop around and damage the inside of your fenders, and your levers. So the trick is to leave them just loose enough so they can be moved around, but yet stay in place without falling. Problem is, over time they come loose and fall down anyway if you don't lock them down super tight. Which takes you back to the first problem again! So this is my attempt at a fix for this. These stops simply slide over the seat belt bracket, and you bolt the seat belt through them. The 180° flat edge stops the seat belt from rotating any further than necessary. Now you can have a free moving seat belt without it damaging your tractor, or getting in the way of turning the seat around. Plus you can still use your seat belt if you wish! I had one of these stops slide on perfect on one side, and the other required a bit of force. Probably variances in the metal bracket itself, or the paint on the bracket could be thicker in different spots. But they both did fit my 1025r TLB perfectly fine. These are a trial and error kind of design, so only time will tell if this is a good fix or not. Enjoy!

Print Settings

Printer Brand:

FlashForge

Prusa

 

Printer: 

Dreamer

MK3S+

Rafts:

Doesn't Matter

Supports: no

Resolution:

.3mm layer height is what I used.

Infill: 

15% honeycomb is what I used.

 

Notes:

I printed these seat belt stops in Proto Pasta HTPLA @220°c nozzle, and 65°c on the build plate, with purple glue stick for adhesion.

Instructions: Place nut into the corresponding hex hole in the bracket by going through the wide opening hole on the opposite side of the bracket, then slide the bracket onto the metal frame. Then place the circular bushing with step facing out into the wide hole. Place the seat belt over the step and then bolt together. NOTE: the factory washers are no longer needed.

 

 

 

Category: Parts

Tagi