BTT HDMI7 V1.2 frame top mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case that mounts to 2020 extrusion frame of printer at a 30 degree angle.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 152
- Wydruki
- 0
- Wyświetlenia
- 1247
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This is a case for the BTT HDMI7 V1.2 that mounts to the 2020 extrusion frame of your printer at a 30 degree angle.
I created this after printing another version that sits at the bottom of the printer in place of current screen on my Voron 2.4. While I enjoyed that version, I did not feel it was in a safe location due to having small children being able to walk up and interact with it (potential fire hazard). Also I felt in my case, it sat a bit too low and the angle wasn't very good for interacting with it. Plus I wanted to be able to print a sweet skirt for my printer :)
Additionally, this case mount takes into consideration having a 3mm cover placed on top of your frame.
Two versions are available. One has side cutout for hdmi/usb cable and the other has a back cutout. There is a third version not included right now that is much larger (twice as wide due to wings on each side), however not included at this time.
Although made for my Voron, it will work with any printer that uses 2020 extrusions.
Printer settings:
Print open side up with supports (needed for the 2020 extrusion angle)
8-15% Gyroid infill
Credit to @cobretti for the measurements (though needed minor adjustments): https://www.printables.com/model/679061-btt-hdmi7-v12