Tap Handle for Arthritis or Children
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I designed this Tap Handle Adapter to help with my kids turning off the tap in their bathroom.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 45
- Wydruki
- 1
- Wyświetlenia
- 220
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial
I designed this handle adapter for the kids bathroom to help them with turning off the tap. I recently replaced the tap and it's stiff to close for some reason. And instead of undoing everything again which was a nightmare in the space it's in, i designed this to help shut the water off.
I purchased a similar device from Bunnings,(hammerbarn) unfortunately it just doesn't work as it doesn't fit these tap handles even though it's supposed to be designed for them.
Print in PLA+ or PETG for best results. Support is needed for the underside.
To install, just side the long handle over the tap first and then pivot the handle into place, it should be a little tight to install so some flex in the material is recommended.
You can shorten the handle if it's too long.