Creality K1 Door Handle Cap w/ New Logo
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Made to fit over the original door handle, avoid finger prints on glass door and maintain potential resale value.
- Ocena
- 5 / 5
- Polubienia
- 29
- Pobrania
- 285
- Wydruki
- 2
- Wyświetlenia
- 1158
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The design seems to be pretty rigid but it's a press fit so please assemble with caution.
To fit it onto the original door handle, remove the original handle from the door. Turn the original handle at about a 45 degree vertical angle then carefully press fit it into the cap. Once the original door handle is in, press it back towards the cap opening until it seats against the embossed inner rim.
Use small pliers with tape wrapped around the teeth to prevent damage when seating the original handle into the cap. (highly recommended)
- Filament: Polymaker-PolyLite PLA (Steel Grey)
- Slicer: OrcaSlicer
- Speed: Silent (25% which I believe equates to 75mm/s) Manufacturer Recommended: 40-60mm but it printed just fine.
- Infill: 40%
- Support Threshold Angle: 35-Normal (Auto)
- Patterns: All Rectilinear
Enjoy your new handle! Print On!!