10s2p (36v) 21700 battery pack w/ BMS
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Specific upper and lower battery pack pieces with features to use DALY BMS
- Ocena
- 0 / 5
- Polubienia
- 19
- Pobrania
- 135
- Wydruki
- 0
- Wyświetlenia
- 1312
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model includes 2 pieces, an upper and lower case for a 10s2p battery pack. Dimensions are 150x95x76mm (about 155x100x80 after heat shrink wrap).
8mm wide slots along top and bottom for 8mm nickel / copper strips.
The design loops around for a more “square” shape instead of a super long design. To complete the circuit, the outer loop uses a soldered wire (14awg) connection instead of welded strip on the LOWER case.
There is a small cutout on the LOWER to fit a DALY standard 36v BMS in the print (held in place with kapton tape) with slots through the UPPER that allow the main in/out wires to connect to the top side of the pack.
Positive side connections (every other "pair) and S#1 negative connection are cut through completely between the batteries and then have a 4mm hole off one side to allow for a BMS wire (22awg) to pass through the case to the battery and be soldered to the end.