10s2p (36v) 21700 battery pack w/ BMS
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Specific upper and lower battery pack pieces with features to use DALY BMS
- Rating
- 0 / 5
- Likes
- 19
- Downloads
- 135
- Makes
- 0
- Views
- 1,321
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This model includes 2 pieces, an upper and lower case for a 10s2p battery pack. Dimensions are 150x95x76mm (about 155x100x80 after heat shrink wrap).
8mm wide slots along top and bottom for 8mm nickel / copper strips.
The design loops around for a more “square” shape instead of a super long design. To complete the circuit, the outer loop uses a soldered wire (14awg) connection instead of welded strip on the LOWER case.
There is a small cutout on the LOWER to fit a DALY standard 36v BMS in the print (held in place with kapton tape) with slots through the UPPER that allow the main in/out wires to connect to the top side of the pack.
Positive side connections (every other "pair) and S#1 negative connection are cut through completely between the batteries and then have a 4mm hole off one side to allow for a BMS wire (22awg) to pass through the case to the battery and be soldered to the end.