1 / 2
Parametric Ball Bearings (Print in Place) — zdjęcie 1
1 / 2

Parametric Ball Bearings (Print in Place)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

PIP Ball Bearings made in Ondsel (FreeCAD). You can change parameters using the spreadsheet.

Ocena
5 / 5
Polubienia
67
Pobrania
557
Wydruki
2
Wyświetlenia
2036
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

PIP Parametric Ball Bearings

 

Made in Ondsel(FreeCAD), change the parameters in the spreadsheet (Bearing Data)

Parameters included:

  • ID
  • OD
  • Width
  • Ball Clearance
  • Shoulder Diameter
  • No. of Balls
  • Chamfer

Refer to the spreadsheet below:

 

 

 

 

 

 

 

Insert the values in A (row 3, not row 2), consequently you can add values in A through E and change the configuration of Inner Race in the Property View as shown below

 

 

 

 

 

 

Note: [Although I don't recommend cycling through configs as the FreeCAD solver messes it up sometimes, I suggest changing values in A, one at a time, and updating to get the required result]

You can get your needed values from SKF catalogue for deep groove ball bearings.

Special Note: Do not use layer height 0.3mm or higher, the smaller the bearing go finer layer heights, 0.2mm is a good start, but I recommend going lower than that to prevent defects. 
I recommend loosening the bearing a bit in post processing by spinning it a few times before use.

Print Settings:

Printer: Ender 3 V3 SE
Layer Height: 0.2mm/0.12mm
Infill: 20%
Wall Count/Shell Thickness: 3 or more
Supports: Yes
Only on Build Plate: ON
Filament: PLA

 

Tagi