1 / 2
Parametric Ball Bearings (Print in Place) — image 1
1 / 2

Parametric Ball Bearings (Print in Place)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

PIP Ball Bearings made in Ondsel (FreeCAD). You can change parameters using the spreadsheet.

Rating
5 / 5
Likes
67
Downloads
557
Makes
2
Views
2,036
Reviews
2

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

PIP Parametric Ball Bearings

 

Made in Ondsel(FreeCAD), change the parameters in the spreadsheet (Bearing Data)

Parameters included:

  • ID
  • OD
  • Width
  • Ball Clearance
  • Shoulder Diameter
  • No. of Balls
  • Chamfer

Refer to the spreadsheet below:

 

 

 

 

 

 

 

Insert the values in A (row 3, not row 2), consequently you can add values in A through E and change the configuration of Inner Race in the Property View as shown below

 

 

 

 

 

 

Note: [Although I don't recommend cycling through configs as the FreeCAD solver messes it up sometimes, I suggest changing values in A, one at a time, and updating to get the required result]

You can get your needed values from SKF catalogue for deep groove ball bearings.

Special Note: Do not use layer height 0.3mm or higher, the smaller the bearing go finer layer heights, 0.2mm is a good start, but I recommend going lower than that to prevent defects. 
I recommend loosening the bearing a bit in post processing by spinning it a few times before use.

Print Settings:

Printer: Ender 3 V3 SE
Layer Height: 0.2mm/0.12mm
Infill: 20%
Wall Count/Shell Thickness: 3 or more
Supports: Yes
Only on Build Plate: ON
Filament: PLA

 

Tags