Prusa Mini 10mm Y axis belt upgrade printable parts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Printable parts from original Prusa Mini to fit 10mm belt and it's pulleys.
- Ocena
- 0 / 5
- Polubienia
- 29
- Pobrania
- 59
- Wydruki
- 0
- Wyświetlenia
- 1453
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Printable parts from original Prusa Mini to fit 10mm belt and it's pulleys. Should increase stiffness of y axis belt and, teoretically, allows to inchrease accelerations without receiving more ringing.
Can't test it properly because after I installed it, I realised, that input shaper at my klippered prusa mini was configured incorrectly (don't use adxl345, this is evil). But after correct calibrating and installing this upgrade, i've managed to inchrease accelerations from 2400 mm/s^2 to 3000mm/s^2 with the same ringing level.
To install this upgrade you will need:
- 500mm of 10mm width belt (gt2)
- pulley wheel 16T with 5mm bore for 10mm belt
- pulley idler for 10mm belt and 3mm bore
- some tools and patience
Highly recomended to print it with PETG or ASA/ABS. DO NOT USE PLA. It may bend because of heat or creep deformation.