The Missing Minimal Vision Pro Case with AirTag support
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Compact and safe Vision Pro protection when combined with the Apple front cover. Easily fits in backpack.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 129
- Wydruki
- 0
- Wyświetlenia
- 1076
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Virtual Reality
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted to be able to carry my Vision Pro in a camera compartment of my Peak Design Everyday Backpack. I felt that any of the Vision Pro cases were too bulky when I already had protection from my backpack. All that was missing was a solution to cover the lenses of the Vision Pro while also using the Apple front cover for the front screen protection.
Since the Vision Pro lacks “Find My” support, I also integrated an AirTag slot.
All you need after printing this file is a 2" wide and 12" long velcro strap to wrap around and keep the Minimal Case in place together with the Front Cap. I'm using a stretchable Wrap-It strap.
NOTE: this was designed for my 21W light seal, I have tried it on a few other ones and it seems to work, though it might not be as much of a prefect fit.
Printing instructions:
- strong PLA (I use Atomic Filament Marble)
- 0.1mm layer height
- 0.2mm initial layer height
- 3 wall loops
- 15% rectilinear infill
- on Bambulab P1P I reduced the overall printing speed by half to get a nicer finish
- optional build plate only support if you think it's necessary