ATX Power Supply Control Module for Eurorack
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For controlling the power supply that you obviously have in your eurorack.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 340
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
No schematics. Grab a couple of wood screws, an 20 pin extension and go to town.
Wire the toggle switch between PS_ON(green) and GND(Black)
Wire the LEDs (with appropriate resistors) to 5VSB(purple,330ohm), PWR_OK(white,330ohm), 5v(red,330ohm), and 12v(yellow,1kohm)
(common color code was specified, check the pinout before you fry anything)
I hooked the 5v standby rail to a 4 pin molex male, this is optional, there is a hole in the case for it. Use some sort of screw and washer in the provided post to keep everything from jiggling around.
The screws that hold the case together are #6 x half inch wood screws. In metric that would be something like 2.5mm by 10mm. It's not too critical.
See the rest of the collection here:
https://www.printables.com/@Beefdip_176978/collections/1432728
Github Page for the project with Openscad/Freecad Sources