Stand for Chinese Hydrometer or Thermometer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
fits classic meter that can be purchased on ebay, aliexpress, etc.
- Ocena
- 0 / 5
- Polubienia
- 33
- Pobrania
- 171
- Wydruki
- 1
- Wyświetlenia
- 582
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Designed and tested this simple holder.
Uses about 6g of filament.
2 versions available, 85 and 80 degrees tilt.
85 degrees = good for higher placement of the meter (e.g. on the closet/wardrobe, etc.)
80 degrees = good for lower placement (table, bookshelf, etc.)
Print settings are not strict and may vary.
Only print orientation is important (face down - see picture).
I printed with 0,6mm diameter nozzle and 0,3mm layer height on MK3S and also with 0,4mm nozzle and 0,2mm LH on MK4.
Both with PLA and PETG.
Feel free to support me on ko-fi https://ko-fi.com/kutilman
I can also sell my source files if you want to save some time designing.