WLED + ESP32 Holder box with magnet lid. Vol. 2!
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The box for WLED controller based on ESP32 based on the ElectroCookie board. Now with a relay, IR, and 2 lines of LEDs.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 51
- Wydruki
- 0
- Wyświetlenia
- 813
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This model is a box to support enhanced version of DIY LED controller based on WLED + ESP32.
I printed the model using PLA with both Standard and Strength OrcaSlicer settings. It worked perfectly fine. No support is needed.
Disclaimer: You probably don't know what you are dooming yourself to! Please, go ahead and buy a prebuilt controller from DrZzs shop! You will have a well-designed and fully working solution that only seems expensive.
However, if you are fine with some soldering, cutting and fitting… ;)
The project was inspired by Makers Mashup video: WLED & ESP32: The Dynamic Duo of DIY LED Projects.
This time, I added:
- support for a relay that fully cuts the LED power when you switch them off. Here is a nice video that explains the reasons: Extend the life of your LED Power Supply | WLED + Relay + DigQuad.
- support for IR sensor that magically works with any IR Remote control. Here is a video about such a solution: Level Up Your WLED Projects: A Guide to adding Components (no code!)
- support for Logic Lever Shifter. Here is the explanatory video: Logic Level Shifter and WS2812b LEDs
- 2 Data lines. Here are some explanations: LED Setup: Using Multiple Data Pins + WLED Configuration. EASY Setup
To assemble the resulting product, I used:
- 4*2mm Neodymium Magnets from temu.com
- 30W Universal Multi-Voltage Fast Charger from temu.com
- 2 Pin And 3 Pin 5 PCB Mounting Screw Terminal Connectors from temu.com
- 20pcs Aluminum Electrolytic Capacitor 2200UF/16V from temu.com
- 10pcs PG7 Waterproof Nylon Plastic Connector from temu.com
- Teyleten Robot ESP32S ESP32 ESP-WROOM-32 Development Board amazon.com
- ElectroCookie Solderable Breadboard PCB Board from amazon.com
+ Additional
- One Channel Relay Module Relay Switch from temu.com
- KeeYees 4 Channels Logic Level Converter Bi-Directional Module 3.3V to 5V Shifter from amazon.com
- Infrared Receiver Sensor Module from temu.com
- 2 Pin And 3 Pin 5 Mm/0.2" Spacing PCB Mounting Screw Terminal Connectors from temu.com
- 22 AWG Stranded Electrical Wires from temu.com
- 10 Pairs 12V DC Power Connector 5.5mm X 2.1mm from temu.com