Logitech C270 Mount for Prusa MK4
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mashup of In3DSpace's (89mm) C270 mount for MK3 and Rokkdaddy's mount for MK4.
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 102
- Wydruki
- 1
- Wyświetlenia
- 532
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
I used a version of In3DSpace's C270 mount on my MK3S+. After upgrading to a MK4, I wanted to mount my camera similarily. Rokkdaddy's C270 mount had the correct look to fit with the MK4 X-motor mount, but too long arm for my use (my enclosure's pocket doors would have hit the camera). So, I decided to spend way too long to mash the two different mounts together, and then rework the camera end for a tighter grip (to avoid the camera drooping too easily).
Same hardware needs as In3DSpace's version:
- 1x M3x18 screw for attaching the mount to the X-motor.
- 1x M3x25 screw for attaching the camera to the mount.
The tighter camera grip is quite tight, so in case that's not working for you, I included a version with the camera end left as is in In3DSpace's original model.
Changelog
- 2024-07-02
- Shorten arm by about 1.6mm, bringing it closer to the stated 89mm length (for the unmodified camera end, the total length is exactly 89mm, my modified camera end adds 0.77mm). I mainly did this because I needed to shave off a little length to fit properly in my enclosure, but it had the added bonus of simplifying the Fusion 360 source.