Logitech C270 Mount for Prusa MK4
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mashup of In3DSpace's (89mm) C270 mount for MK3 and Rokkdaddy's mount for MK4.
- Rating
- 5 / 5
- Likes
- 12
- Downloads
- 102
- Makes
- 1
- Views
- 532
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
I used a version of In3DSpace's C270 mount on my MK3S+. After upgrading to a MK4, I wanted to mount my camera similarily. Rokkdaddy's C270 mount had the correct look to fit with the MK4 X-motor mount, but too long arm for my use (my enclosure's pocket doors would have hit the camera). So, I decided to spend way too long to mash the two different mounts together, and then rework the camera end for a tighter grip (to avoid the camera drooping too easily).
Same hardware needs as In3DSpace's version:
- 1x M3x18 screw for attaching the mount to the X-motor.
- 1x M3x25 screw for attaching the camera to the mount.
The tighter camera grip is quite tight, so in case that's not working for you, I included a version with the camera end left as is in In3DSpace's original model.
Changelog
- 2024-07-02
- Shorten arm by about 1.6mm, bringing it closer to the stated 89mm length (for the unmodified camera end, the total length is exactly 89mm, my modified camera end adds 0.77mm). I mainly did this because I needed to shave off a little length to fit properly in my enclosure, but it had the added bonus of simplifying the Fusion 360 source.