1 / 4
Wooden Train Traffic Light for IKEA LILLABO, Brio and others. — zdjęcie 1
1 / 4

Wooden Train Traffic Light for IKEA LILLABO, Brio and others.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A traffic signal for IKEA and other wooden train tracks.

Ocena
4,815 / 5
Polubienia
224
Pobrania
969
Wydruki
35
Wyświetlenia
4729
Oceny
27

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Building Toys
Licencja
Creative Commons — Public Domain

First, many thanks to Romain for inspiring this remix.  

My grandsons only know full speed and sometimes stop. So, the yellow caution lamp was replaced with a sliding shutter, exposing either the red or green ‘lamp’.   Gravity reared its ugly head in the first iteration requiring the addition of a detent spring to hold the shutter in the up position. The detent spring prints in place. 

I opted for a two piece print such that the traffic signal's post can be printed flat for improved strength.

Assembly 

  1. The red and green ‘lamps’ press fit into the signal.  Ensure they are fully seated and are slightly below the shutter's sliding slot.
  2. Place the shutter in slot and test the detent spring action. If all is well, the shutter should slide smoothly with a nice snap action at the limits. (Prusa…thanks for adding ironing to PrusaSlicer)
  3. The cover snaps in place but I opted for a bit of Loctite 401 on outward facing surfaces of the tabs to ensure the cover cannot be removed.  Don't glue the inside surface as excess glue may contact the shutter.
  4. Glueing the post to the track is optional.

The track fits IKEA Lillabo tracks but should be compatible with Brio and other wooden track sets. The Fusion 360 file is included if you need to tweak track dimensions for other than IKEA products.

Printing Guidelines

  • Filament: PLA
  • Layer Height: 0.2mm Quality
  • Perimeters: 2
  • Infill: 15% Gyroid
  • Supports: None
  • Ironing: Yes, All top surfaces (less post printing processing for close fit between signal, shutter and cover.
  • The .3mf file contains all the printing parameters I used.
  • Shutter: color change was used for the shutter's tab.

Tagi