SV07/SV07+ Cartographer/Beacon Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A mount for mounting a Cartographer/Beacon eddy current probe SV07/SV07+
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 43
- Wydruki
- 1
- Wyświetlenia
- 842
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
a mount for mounting a Cartographer/Beacon eddy current probe on the SV07/SV07+
this was designed for the Cartographer in right angle configuration and the SV07 but i believe it should work for the Beacon and the SV07+ (Fusion file included if changes need to be made).
it mounts to the printer on the right of the tool head using the screw hole and indexing holes that the large stock shroud uses. i did not want to replace the stock mount since i am using that to mount a drag knife and i didn't want to have to incorporate that into this design.
the mount has an X offset of 25mm, Y offset of 0mm and Z offset of about 1.5mm (remember to tune the z offset to your printer)
NOTE: i have seen reports that the stock screen/pi on the SV07 is not powerful enough to process the data from the probe. i was already using a Raspberry Pi 4 when i got the probe so i never tried it with the screen but if you run into issues they may be related to this.