1 / 1
Floating Soap Dish with Bottom drainage
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A floating soap dish with a mesh at the bottom for ultimate drainage
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 29
- Wydruki
- 0
- Wyświetlenia
- 192
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Share Alike
See this post:
My next approach to handling the soap bar problem: a floating soap dish with a perforated bottom so drying and draining from below can happen.
My journey so far:
1. standard soap dish. It's a slurry mess.
2. fancy soap dishes with spikes to hold the soap bar up. Still a mess.
3. hanging soaps with a loop of string. Works amazing, but drilling holes into soap is uncool.
4. (I don't like soap nets)
5. (oldschool crown cap&magnet-style)
6. This one! Wish me luck!
Instructions
- Set bottom and top layers to zero, especially for the bottom of the dish (e.g. use a modifier for that)
- Use a high-percentage infill (e.g. 50%) such as Gyroid
- optionally increase the extrusion width (e.g. 1mm)
- Stick the dovetail slot to a flat wall e.g. with Tesa Powerstrips