1 / 6
Heltec v3 (or other) Antenna Mounted Weather Resistant Case — zdjęcie 1
1 / 6

Heltec v3 (or other) Antenna Mounted Weather Resistant Case

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Case slips over an existing external high gain antenna. Weather resistant. Room for 2000mah lipo battery. sma to n type

Ocena
0 / 5
Polubienia
30
Pobrania
104
Wydruki
1
Wyświetlenia
1717
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Engineering
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Use PETG or other outdoor rated filament. PLA will become brittle in the sun. This case is designed to slip over a standard external fiberglass antenna and mounts right on the (mounting) portion of the antenna. There shouldn't be any way it falls off. There is room inside for a 2000mah lipo battery and a heltec v3 or similar sized board. I used an SMA to N type pig tail to connect to the antenna for minimum signal loss.  There are two portholes in the case cap for the signal wire USB wire. There are internal rests for the cap so it doesn't go in to far. The cap friction fit for me well, however, I made 2 small holes on the outside for a pin or small bolt if you want it to be more secure. There is also a nub with a hole in it for something to grab while removing the cap. You can use this nub with through hole to put the pin the whole way through or put a keychain ring to open it up. You may also do nothing and grasp it with plyers, many options. 

Here is a link to all the parts used:

Heltec v3: https://www.amazon.com/dp/B086ZFCV7F

SMA to N Type Pigtail: https://www.amazon.com/dp/B08ZYK5SL9

2000mah lipo battery: https://www.amazon.com/dp/B08214DJLJ

5.8db Fiberglass External Antenna: https://www.seeedstudio.com/RF-Explorer-LoRa-Fiberglass-Antenna-Kit-902-930MHz-5-8dBi-800mm-p-5275.html

I added a second version that uses Dimples instead of holes
 

Tagi