Vase Mode Blocky Pots
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Two simple pots, designed for vase mode and orchids
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 29
- Wydruki
- 0
- Wyświetlenia
- 252
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
Two simple orchid pots desingned to be printed in vase mode
ø: 12cm
height: 12cm
Best with a big nozzle, at least a .8mm I would say, for good solidity
preferably in a translucent / transparent material for orchid roots light exposure
With a layer height big enough it prints in no time and the transparency seems better.
The blocky design already provides holes for aeration and drainage.
You may add some holes on the bottom with a soldering iron or a drill.
And even more on the side of the smooth one if you like.
Print Settings
Printer Brand:
Creality
Printer:
CR-10S
Rafts:
No
Supports:
No
Resolution:
1mm nozzle; .8mm layer height
Filament: Daylifil PET-G Naturel translucide
Notes:
Designed to be printed in vase mode, or print with no infill no top layer and play with shell thickness.
Watch out for bottom thickness, set it around your shell / extrusion width value,
2 or 3 layers are enough.
And check if your slicer tries to close the top.
Post-Printing
Make more holes for drainage and aeration, using a drill or a soldering iron (in a ventilated area, or/with an adapted respirator mask)
Category: Outdoor & Garden