1 / 1
Ikea KADRILJ adapters for 45mm aluminium tube - extension. — zdjęcie 1

Ikea KADRILJ adapters for 45mm aluminium tube - extension.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Adapter set to extend your Ikea KADRILJ blinds to almost any length with 45mm aluminium tube.

Ocena
0 / 5
Polubienia
0
Pobrania
12
Wydruki
0
Wyświetlenia
203
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Adapter set to extend your Ikea KADRILJ blinds to almost any length.

Designed for 45mm in diameter, 2mm thick aluminium tube. This sums up to 41mm inner diameter, like the original tube.

Please read the instructions and important note at the end for compatibility details.

Printing:

I printed my spacers on Prusa MK2.5s with PETG at 0.6mm nozzle/0.2mm layer with 25% infill. Motor adapter is printed with 100% infill.

Prerequisites: 

  • Shorter-than-needed KADRILJ blinds.
  • Aluminium tube cut to desired length and with new material already attached.

How to install:

Disassembly:

To take the unit apart, there are just three screws on the top of blinds. After unscrewing both you should be able to slide aluminium part from the both ends apart.

Motor is inside the tube on “battery” end. The other end contains just a plastic slider that you can easily pull out.

To remove the motor from original tube simply pull it straight out. Be careful as the motor is connected with a few wires to the main body.

Modding:

You need to cut upper part of your blinds (the aluminium frame) in half. That's the only physical mod needed.

Print all the parts needed. Put spacers on top of each end caps. Replace the motor adapter with printed one - it is held to motor with a single screw. Put a new tube - you will need some force as it is a snug fit.

If you find that the motor is still spinning inside, adapter is made in a way so you can drill two holes from the opposite sides of metal tube and put some screws in.

Mounting:

“Bring your own idea”. Since we cut blind in half, two OEM mounts are not an option anymore. You can find some magnetic mounts in here: https://www.printables.com/pl/model/68628-ikea-fyrtur-and-kadrilj-magnetic-window-mount

I just use 3M VHB tape to adhere blinds directly (and flat) to the window frame.

Important notes: 

Different variants

To my knowledge FYRTUR blinds use different size tube so it won't work. 

There are at least two styles of original tube in KADRILJ blinds. They differ in the metal tube itself and thus all three elements that mate the tube with the frame.

To distinguish them - after taking your blind aparts look inside the original tube. If it looks like this, they need end cap spacers to be printed. I found those in 60cm blinds. 

The other variant has a very tiny protruding elements and IIRC it was already 41mm in diameter - you can likely just put the new tube directly over the OEM parts.

End stops

Please remember those blinds are… a bit blind. They don't have stop sensors, starting position is determined by measuring physical resistance of the spinning motor and length is measured just by counting motor rotations.

Thus the strip used at the end of your new blinds material needs to be rigid and wide enough so when rolled up it will catch to both ends of blinds case. Otherwise the controller will just spin around.

Tagi