1 / 2
The Nautilus + LED strip - Sovol SV06 PLUS Fan Duct 5015
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of 3DRibo's adaption of The nautilus for the SV06 PLUS and Jonybat's LED strip.
- Ocena
- 5 / 5
- Polubienia
- 32
- Pobrania
- 249
- Wydruki
- 2
- Wyświetlenia
- 1768
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 2) (Komentarze: 5)Remiksy (0)Kolekcje (54)Powiązane
There are already many iterations of the very popular Nautilus, so I won't be adding much but the links to the sources with all the information you need.
The only differences from the other links are:
- The lengths of the screws used for the nautilus, in my case I needed 26mm countersunk screws, they just go straight through plastic until they reach the thread on the front side of the extruder, not interfering with the extruder board. (this seems to be the case with the PLUS model)
- The Mosfet I used was different from the one used by @Beau Slim, but achieved the same result. And eventually changed it to be controlled by the Raspberry Pi running the printer, instead of the pins (PA13/14) in the Printer's MCU
Original The Nautilus by @Leander Perez Blanco
PLUS Version by @3DRibo
LED Version by @Jonybat
Mosfet instalation adapted for the LED by @Beau Slim