Table Base for Noctua Fan and Airflow Amplifier
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Base for CL33's remix of the NV-AA1-12 Airflow Amplifier (which adds a mount)
- Ocena
- 5 / 5
- Polubienia
- 50
- Pobrania
- 203
- Wydruki
- 4
- Wyświetlenia
- 2225
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This base is to support a 120mm Noctua fan with an NV-AA1-12 Airflow Amplifier. You need to print CL33's remix which adds a mount https://www.printables.com/model/889753-nv-aa1-12-airflow-amplifier-action-cam-mount
There are two version, one has small clips for holding a Noctua fan speed controller. The bolt is M5 (in case you need to improve the plastic screw threads in the base using a bolt or tap).
Mount the fan+amplifier so the fan is towards the longer side of the base (the fan is heavier than the amplifier). I used PETG because I think PLA might be too brittle.
The screw with the 98% scale thread make screw in easier but it may also not hold a well. You can always just use an M5 bolt.