Table Base for Noctua Fan and Airflow Amplifier
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Base for CL33's remix of the NV-AA1-12 Airflow Amplifier (which adds a mount)
- Rating
- 5 / 5
- Likes
- 50
- Downloads
- 203
- Makes
- 4
- Views
- 2,219
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Bedroom
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This base is to support a 120mm Noctua fan with an NV-AA1-12 Airflow Amplifier. You need to print CL33's remix which adds a mount https://www.printables.com/model/889753-nv-aa1-12-airflow-amplifier-action-cam-mount
There are two version, one has small clips for holding a Noctua fan speed controller. The bolt is M5 (in case you need to improve the plastic screw threads in the base using a bolt or tap).
Mount the fan+amplifier so the fan is towards the longer side of the base (the fan is heavier than the amplifier). I used PETG because I think PLA might be too brittle.
The screw with the 98% scale thread make screw in easier but it may also not hold a well. You can always just use an M5 bolt.