HeyGears Ultracraft Reflex Wash Bucket Build Plate Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This shim will allow you to put your HeyGears Reflex build plate inside your wash bucket.
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 138
- Wydruki
- 0
- Wyświetlenia
- 965
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This shim will allow you to use your HeyGears Reflex build plate inside your wash bucket. The shim is pressure fit, and will line up roughly with the max fill line of the bucket itself.

I tend to print a full build plate of smaller items, and found that the wash buckets would cause the prints to scratch each other during a wash. I've resorted to washing the entire build plate with prints attached, but found that the build plate itself would sink towards the bottom, and the models themselves were holding the build plate up inside the wash bucket.
Printing:
- Print on an FDM Printer using a chemical-resistant filament. (PETG, ASA, etc)
- Flat side goes on the build plate.
You can also use it to drain the build plate after washing, by propping your build plate up on the shim itself (forgot to photograph that, will fill that in later)
–

This is V1, I mocked it up quickly because I needed one STAT. If you have any ideas after using it for a while, leave a comment below. I'm open to refining this over time!