1 / 6
Sovol SV06 5020 part cooling fan duct for Volcano nozzle
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fan duct using 5020 blower for SV06 adapted to use Volcano nozzle using melt zone extender and stock heater block.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 55
- Wydruki
- 0
- Wyświetlenia
- 573
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 1)Remiksy (0)Kolekcje (10)Powiązane
This is a fan duct using 5020 blower fan I use with my SV06 adapted to use Volcano nozzle using melt zone extender and stock heater block.
Use at least PETG to print this, ABS/ASA is recommended.
You'll need:
- 24v 5020 blower fan using JST 1.25mm 2 Pin,
- two short M3 screws (I used 8 mm) and nuts
- one M4 screw 28mm or slightly longer
You should be able to reuse screws from the back of extruder mount to attach the duct frame. Two “insets” on the top of the frame should allow for some cable management.