IKEA ADILS Snap-On Spacer (50mm and 70mm)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a spacer to snap onto the IKEA ADILS table leg. It is used to create a constant gap between wall and table top.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 44
- Wydruki
- 1
- Wyświetlenia
- 253
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a spacer that snaps onto the IKEA ADILS table leg. It is used to create a constant gap between the wall and the tabletop. It is also intended to prevent the table top from accidentally hitting the wall.
I took inspiration from @LB4FH's standoff. Thanks for that.
Reason:
We built a new IKEA desk with an ALEX drawer unit on one side and two ADILS legs on the other. The ALEX drawer unit was mounted in the middle of the Lagkapten table top, so that there is a gap of 10 mm to the ALEX on the front and back. In our house we have a skirting board with a depth of 20mm.
Long story short: The distance between the table top and our wall is 10mm.
Problem:
The ALEX drawer unit sits directly on the skirting board, while there is still 50mm of space between the rear ADILS leg and the wall. This is why it often happens that the table top on the ADILS side is pressed against the wall when standing up.
Solution:
I designed two snap-on spacer to prevent the table top from hitting the wall. The 70mm spacer is for the upper side of the ADILS leg, to snap-on directly under the ADILS mount (spacer between leg and wall). The 50mm spacer is for the lower end, between leg and skirting board. Because the leg is a little springy at the bottom, you should consider using the top spacer. Or simply use both.
NOTE:
The distance for the spacers is measured from the center of the ADILS leg to the wall or the skirting board. If you are not sure, measure from the bolt, where the ADILS leg is mounted, to the wall / skirting board.
Usually it's 60mm from the bolt to the edge of the table, so add the amount of your gap and see if the spacers fit.
My Print Settings:
Rafts:
No
Supports:
No
Perimeter:
5 (use at least 3)
Resolution:
0.2
Infill:
25%
Filament:
PETG