USB TF micro SDcard Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
USB, TF, micro SD, SDcard Holder using Vase mode (Spiralized outer contour in Cura).
Holes for mounting are 3mm.
This is a remix of
https://www.thingiverse.com/thing:4499792
which is a remix of
https://www.thingiverse.com/thing:2835728
Print Settings
Printer:
Geeetech E3D V6
Rafts:
No
Supports:
No
Resolution:
0.28mm or less
Filament: Generic PETG or PLA-F or PLA
Any
Notes:
You may need to increase line width from standard 0.4 to 0.5 +5% to 10% flow or 0.6 +10% to 20% flow to get a tighter fit depending on your printer tolerances. you can test using test piece.
Base plate is 1.4mm thick and needs initial layer and bottom thickness to be this size.check you bottom layer count to make sure it is 1 less then the start of vase or spiral contour layer (if vase starts at layer 6 you want 5 bottom layers)
I used 0.28mm for my initial layer and layer height. 5 bottom layers
Category: Computer