Ender 3 Pro - Sturdy Feet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A sturdier foot build for the Ender 3 (2020 extrusions)
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 93
- Wydruki
- 1
- Wyświetlenia
- 663
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
I was really struggling with Cooling under my Ender 3 a while back so printed the “Voron Like” theme kit for the printer.
https://www.printables.com/model/385532-ender-3-pro-voron-themed-electronics-enclosure
This enclose solved most of my problems but gave me 2 problems
- Made id difficult to clean under my printer
- Feet weren't sturdy enough for me and i was noticing slight wobble when printing and higher speed accelerations
so i designed these.
Yes it:
- Uses a lot of screws and source map nuts (8 of each)
- Yes you need some TPU For the pads
- Yes uses a fair amount of Material for the main bit
But it:
- Pretty much gets rid of the wobble
- gives the printer an even better base
- Is really easy to install
- and most importantly! it Looks Good!!
To install simply slip the screws into the holes from the gap in the size and put the T nuts on them and then attach them to the printer…. done…
Optional
You don't actually need glue as i have done in my photos but it will help you when installing them. Only really needs a dab to hold them in place whilst installing.