Servo Mount

As I could not find a suitable mount for my servo, I have decided to design it myself. This model (there are two versions) mainly serves the purpose of mounting the servo to use the winch. This is the 2nd version of the model. That means there is still room for improvement, so please report any issues you encounter.

Print Settings

• Material: PLA or PETG (see below)
• Nozzle Size: 0.4mm
• Layer Height: 0.2mm
• Infill: 100% (see below)
• Supports/Brims: Nope

PETG was used to print this model because I want to mount the servo outdoors (exposed to the sun). If you use the mount indoors PLA should be sufficient. For the infill, I decided to better be safe than sorry and choose 100%. However, an infill of 15% should work as well.

You need four M3x25mm screws to secure the servo to the mount. For mounting the mount you can either use M5 screws or cable ties

Additions parts:

• INJORA 35KG Digital Servo
• M3 screws
• M5 screws
• Cable ties

I have used my reliable Neptune 4 and I can recommend the following filaments:

Please note that the links are affiliate Amazon links. Feel free to click on them to support me. :) Apart from that, you can also support my work by buying me a coffee.

If you print one, please post a make! If you encounter any issues, post a comment. Thanks!

18/06/2024 Update: I have added a “light” version to reduce print time and the amount of material needed. However, be aware that the strength of the model might be affected.

21/06/2024 Update: I have added a tiny snatch block, which will work with a 20 or 25mm M3 screw. However, I have not printed the snatch block, yet. If you print it before me, please give me feedback.