Sidemount Drybox Stand for Prusa XL
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This mounts to your 30x30 extrusion and creates a stand for a drybox
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 510
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
The XL does not like filament unless it is super dry. Leaving the spools exposed on the side while you print is not a good way to get successful prints, so I made this attachment for Dry Boxes. Print with the magnet side down. Use Snug supports and the supports pop right out. I glued a little strip of metal onto the bottom of the drybox but you can also stick some magnets on the inside of the drybox. Whatever drybox you choose. I used these which are the smallest size I could find that fit 1KG spools.
Insert the M4NeS Nuts into the horizontal extrusion. Then use the 2 M4 Bolts to attach the platform right to the horizontal extrusion. Happy Printing!
https://www.amazon.com/gp/product/B0CFLJCJSF/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1Print this with the magnet side down. Use snug supports. The supports pop right out of the magnet holes.
hardware needed:
5x 10x3mm Magnets
2x M4x 12-20mm bolts
2x m4NeS drop in nuts https://www.printables.com/model/891014-spring-loaded-drop-in-m4-t-nut-m4nes or any other drop in M4 nut for 30x30 extrusion
Edit 8.2.24:
I printed in PLA and the mounts sagged over time. I reinforced the platform by adding some gussets underneath. I would recommend printing in PETG to reduce sag.